Replacing The Main Fuse; Maintenance - Technotape 3DT.SUB.OVN.001 User Manual

3d sublimation oven
Table of Contents

Advertisement

MAINTAINANCE
4.1 Maintainance
Switch off the oven and take the power
cable out of the wall outlet. The oven
must be cooled before any maintenance.

4.2 Replacing the Main Fuse

If the oven does not work and the main switch is on, check the main fuse.
To change the main fuse; switch off the oven and pull out the plug of the wall outlet. The oven must be completely cooled down. The
main fuse 10A is placed on the motherboard, which is placed under the hood on the right side of the oven (see image 4.2.1)
Remove the hood from the oven to take out the broken fuse (see image 4.2.2).
Replace with a new fuse (see image 4.2.3). Replace the hood of the oven and put the plug back in and switch on the oven to check
the fuse.
image 4.2.1
image 4.2.2
image 4.2.3
15

Advertisement

Table of Contents
loading

Table of Contents