Table of Contents
Advertisement
WORKING WITH THE 3D SUBLIMATION OVEN
3.5 Get Started
Close the drawer of the oven to start pre-heating (see image 3.5.10).
When the drawer is closed the oven will start the pre-heating process (see image 3.5.11). After the pre-heating process the display
will show: "Ready" (see image 3.5.12).
NOTE: The 3D Sublimation Oven needs approximately 30 minutes to pre-heat before the rst production run.
Open the drawer to place the unprinted sublimation products on the production jigs.
Then place the printed 3D foil and make sure that the foil is placed correctly (see ima-
ge 3.5.13). The foil must be placed under the lips.
NOTE: Print the image onto the matte side of the 3D Foil and let it dry for at least one
production run.
Close the drawer and the pre-heating time will start counting down (see image 3.5.14).
After the foil pre-heating time is nished the process timer will start automatically (see
image 3.5.15). Vacuum is measured in the oven by a transmitter. The measured value
is displayed (see image 3.5.16). The vacuum has to be within the green range. It's
important for the process that there is enough vacuum.
When the process is nished the drawer will open automatically, remove the lm and
remove the nished products from the production jigs. The display will return
to Ready (see image 3.5.17) and you can start a new cycle.
Image 3.2.14
Image 3.2.15
Image 3.5.13
Image 3.5.17
Image 3.2.16
13
Advertisement
Table of Contents
