Table of Contents
Advertisement
WORKING WITH THE SUBLIMATION OVEN
3.1 Quality Guarantee and Support
Technotape can only offer support for the 3D Sublimation Oven
when it's used in combination with a Virtuoso VJ-628 (Mutoh)
Printer, Xtreme Sublimation Foils and Sublimation Products
supplied by Technotape. Other combinations can be possible,
but are not tested and therefore not supported.
Temperature Settings
Press the temperature settings icons (see image 3.2.1). Adjust temperature by pressing the button marked with arrows in the
middle of the control panel, up (see image 3.2.2) or down (see image 3.2.3). After setting the temperature press the home button to
con rm.
Switch on/off
Temperature setting
Image 3.2.1
Vacume Settings
Press the vacuum time button (see image 3.2.4). Adjust vacuum time by pressing the button marked with arrows in the middle of
the control panel, up (see image 3.2.5) or down (see image 3.2.6). After setting the vacuum time press the home button to con rm.
Image 3.2.4
3.2 Setting Parameters
After switching on the oven, make sure that the drawer is
open to adjust the settings. Settings for pre-heating the foil,
temperature and time can be changed by using the display. The
oven is made for 3D Sublimation purposes.
Pre-heating time for the foil
Home icon (return to menu)
Image 3.2.2
Image 3.2.5
Vacuum time
Image 3.2.3
Image 3.2.6
11
Advertisement
Table of Contents
