Cleaning Procedures - Sunrise Medical Jay Dermafloat LAL 1000 Series User Instruction

Jay LAL 1000 Series Standard Low Air Loss System
Control Unit:
1.
WARNING: Disconnect the AC power cord from the wall
outlet before attempting to clean the unit.
Wipe off dust. If necessary, clean the housing exterior with
a disinfectant solution or a mild detergent and a damp cloth.
Then wipe dry.
DO NOT HEAT OR STEAM AUTOCLAVE THE CONTROL
UNIT. NOT EVALUATED AS A STERILE PRODUCT.
NOTE (for 120 volt version): This product incorporates fusing only in the
ungrounded phase conductor. This product must not be used in countries other
than the United States and Canada and must be used only in health care
facilities on grounded systems where conditions of maintenance and supervision
ensure that only qualified persons will service the electrical distribution system.
Low Air Loss Mattress:
2.
The Standard Low Air Loss Mattress can be wiped down with a
disinfectant solution or a mild detergent with a damp cloth. Wipe
dry before remaking the bed.
disassemble mattress soft goods before placing in machine.
Machine washing of the manifold is not recommended, refer to #8
in the general cleaning procedures.
Low Shear Comforter:
3.
Comforters are to be laundered between patient uses and/or as
required for patient hygiene. Fill the washing machine with warm
water 70-140°F (21-60°C). Use laundry detergent and/or standard
hospital disinfectants in recommended concentrations. Start the
washer and let the detergent and disinfectant mix fully. Place no
more than four comforters in a single extra large load capacity
washing machine. When wash cycle is complete, remove promptly
from machine and ensure all excess water is drained from load.
Place dryer on LOWEST heat setting, or AIR FLUFF setting if
available, until dry, not to exceed temperatures of 148°F (50°C).
Verify comforter is completely dry before placing under patient,
refer to instructions on page 14.

CLEANING PROCEDURES

When washing by machine,
10