Cleaning And Care Information; Daily Product Inspection - Sunrise Medical Leckey Sleepform User Manual

p16 Sleepform User Manual
SECTION 10:
CLEANING AND CARE
INFORMATION
Leg/Knee Guides and Chest/Hip Guides
The whole component can be placed in
the washing machine and washed at 40
degrees Celsius.
Breathable Knee Pillow, Breathable
Mattress, Knee Rolls
The outer covers can be zipped off and
machined washed at 40 degrees Celsius.
The special fibre of the breathable mattress,
knee pillow and knee roll can be rinsed
clean under a tap/showerhead and air
dried. These will dry extremely quickly.
Additional or replacement covers are
available.
Mouldable base
Wipe clean with soap and warm water.
Allow the pillow to dry completely before
storing it. If necessary to disinfect, wipe the
complete pillow with a solution containing
70% alcohol. If your child occasionally
soils the bed, we recommend you use a
waterproof and breathable under sheet.
Temperature Control Sheet
The temperature control sheet can be
machine washed at 60 degrees Celsius.
SECTION 11:
DAILY PRODUCT
INSPECTION
We recommend that daily visual checks of
the equipment are carried out by therapists,
carers or parents to ensure the product is safe
for use. The recommended daily checks are
detailed below.
1. Check that the product is clean and there
are no signs of soiling.
2. Check that all fabrics, webbing, Velcro
and plastic buckles are in good condition
and do not show signs of wear and tear
or fraying.
3. Check the mouldable base is firm
enough to maintain your child in the
desired position; air can be extracted if
the mouldable mattress has become soft.
Should the child have lost the desired
position, the mouldable mattress should
be remoulded again to the desired
shape.
4. Check the mouldable base for scratches,
scores or punctures. Seal any holes with
the repair patches supplied with the
product.
Holes can be found by visual inspection or by
fully inflating the mouldable base, covering
the surface of the pillow with soapy water and
watching for air bubbles. If a hole has been
found clean the area and let it dry. Select
a patch and put glue on it and on the area
around the hole. Wait for 2 minutes and firmly
press the patch over the hole ensuring that
no air remains under the patch. The bond will
be complete after 24 hours. DO NOT FULLY
IMMERSE THE MOULDABLE BASE