Installation & Setup - KISS FLTCTRL Flyduino KISS Flight Controller V2 Manual

Note: If you press the Reset (RST) Button after you connected the FC to your PC, the GUI will automatically
switch to the "Flasher" tab once you connect it.
Installation & Setup
Just plug in the FC via Micro USB connection to your PC. Drivers should be installed automatically on WIN7-
10.
After the installation is complete, unplug the FC from the USB, plug it in again and hold the FC firm and level
for at least 5 seconds!
The green LED will be lit constantly while the blue LED will blink, indicating the Gyro calibration. It will be
solid afterwards and go off when the calibration is completed und the FC is ready to go.
Then start the Chrome App or one of the stand-alone GUIs and select the COM port for the connection. If no
port is shown, the driver installation might have failed.
Note: iOS doesn't work with an OTG USB cable so a WiFi module is required.
11