Displaying And Maintaining Clock Monitoring Module - H3C S9500 Series Operation Manual

Operation Manual – Clock Monitoring
H3C S9500 Series Routing Switches
Note:
For a POS interface card, if you set the port clock to work in Slave mode, you must use
the clock lpuport command to set the LPU port of the clock source of the interface
card.

1.8 Displaying and Maintaining Clock Monitoring Module

View the clock base
phase
View the current
configuration of the clock
monitoring module
View the detailed
information of the clock
monitoring module
View the D/A value of the
DAC inside the clock
monitoring module
View the input clock
source port of the line
board
View the lock state of the
clock monitoring module
View the priority of all
reference sources
View the self-test result of
the clock monitoring
module
View the state of all
reference sources
View the SSM level of all
reference sources
View the SSM level of the
output clock signal.
View the clock monitoring
module version
View the work mode of the
clock monitoring module
of the SRPU
To do...
display clock
basephase
display clock config
display clock device
display clock d/a
display clock lpuport
display clock
phase-lock-state
display clock priority
display clock
self-test-result
display clock source
display clock ssm-level
display clock
ssm-output
display clock version
display clock
work-mode
Chapter 1 Clock Monitoring Configuration
Use the command...
1-8
Remarks
Available in any view