Step 2: Setting Up The Isorocker; Step 3: Powering Revitive - Actegy Revitive Circulation Booster User Manual

Instructions for use
STEP 2:
SETTING UP THE ISOROCKER
a Turn the device over so that you can see the
IsoRocker and IsoRocker Disabler.
• The IsoRocker allows REVITIVE to rock while
stimulating your legs and feet.
• REVITIVE will begin rocking on the IsoRocker once
muscle contractions are strong enough.
• When the IsoRocker feature is disabled, by
opening the IsoRocker Disabler, REVITIVE
will be inclined and not rock during use.
b If you want to use the IsoRocker, leave the IsoRocker
Disabler in place (ie flat) on the bottom of the device,
as shown.
c If you do not want to use the IsoRocker
• Pull the IsoRocker Disabler on the bottom of
REVITIVE. You may have to pull hard.
• Pull the IsoRocker Disabler back until it clicks open,
as shown.
• To re-enable, pull the IsoRocker Disabler and press
into place (ie flat) on the bottom of REVITIVE.
14
STEP 3:
POWERING REVITIVE
REVITIVE can be powered from either the rechargeable battery or by connecting
it to an electrical socket.
BATTERY POWER OPTION
If you want to use the device without connecting it to an electrical
socket, it can run from the battery.
When the device is running from the battery, an indicator will show the
remaining battery level.
Full Battery
Follow Step 4 Using The Foot-pads or Step 5 Using the Electrode Body
Pads to continue setting up REVITIVE.
When the battery drops to the low level, it will require recharging.
See Step 6, Recharging Battery on page 26.
If you turn the device off and the low battery level indictor blinks for
10 seconds, the battery requires recharging.
Please note that if the battery runs out, the device can still be used,
by connecting to an electrical socket.
Low Battery
15