Page 2
THANK YOU FOR CHOOSING JBL® For more than 70 years, JBL has been involved in every aspect of music and film recording and reproduction, from live performances to monitoring the recordings you play in your home, car or office. We are confident that the JBL Synthesis loudspeaker you have chosen will provide every note of enjoyment that you expect – and that when you think about purchasing additional audio equipment for your home, car or office, you will once again choose JBL.
SPEAKER CONNECTIONS Since the SSW-3 is a passive subwoofer, only speaker-level connections are available. The SSW-3 subwoofer is specifically designed for use in conjunction with the JBL® Synthesis SDA amplifiers. It is optimized to offer the best dynamics and frequency response with the use of the JBL SDA-4600 amplifier, which is specially designed to use the proprietary SSW-3 tuning file and drive the signature reactive load impedance of the SSW-3.
Page 4
USING TWO SSW-3 SUBWOOFER IN STEREO MODE Receiver/Processor Ampli er Left top/bottom of SSW-3BB back box Line-Level Speaker-Level Subwoofer or Inputs Outputs main Amp out Left Left Left Right top/bottom of SSW-3BB back box Right Right Right INSTALLATION GUIDE A complete SSW-3 loudspeaker system includes the SSW-3 in-wall subwoofer and the SSW-3BB back box. These components are packaged separately.
Installation: 1. Place the Styrofoam™ blocks on the bottom plate of the stud bay. The SSW-3BB back box will rest on top of the blocks. 2. Install the two centering bars as shown in Detail A. The centering bars are for setting the depth of the enclosure. They also help locate the horizontal position of the enclosure as they are mounted into the studs at the left and right to hold the enclosure in the correct location.
Page 6
Back Box with attached centering After Back Box installation After Back Box installation blocks (pre-mounted) remove centering blocks and centering blocks are removed, positioned and installed into stud bay. use wood screws to fill the upper (2) holes in the SSW3-BB, lower (2) holes will be sealed by the baffle gasket.
PAINTING THE GRILLE 1. Carefully remove scrim cloth from the rear of the grille. Clean grille on both sides with alcohol. You can cover the edge trim with masking tape if desired. 2. When the alcohol has evaporated, place the grille on scrap cardboard in an open area away from sensitive surfaces. Paint the front of the grille in light amounts by multiple passes with the spray can or gun.
The maximum recommended amplifier power rating will ensure proper system headroom to allow for occasional peaks. We do not recommend sustained operation at these maximum power levels. JBL, Harman International, JBL Synthesis and Synthesis are trademarks of Harman International Industries, Incorporated, registered in the United States and/or other countries.
Page 10
Китай Импортер в Россию: OOO “ХАРМАН РУС СиАйЭс“, Россия, 127018, г.Москва, ул. Двинцев, д.12, к 1 Гарантийный период: 1 год Информация о сервисных центрах: www.harman.com/ru тел. +7-800-700-0467 Срок службы: 5 лет Товар не подлежит обязательной сертификации Дата производства: Дата изготовления устройства определяется по двум буквенным обозначениям из второй...