Table of Contents
Advertisement
PC2300 Operations Manual
PANEL MOUNTING
Follow the steps below to panel mount the PC2300:
1. Cut out a section of the panel that corresponds to the cut out dimensions shown on
the corresponding dimensional drawing
2. Place the PC2300 through the panel cut out so that the gasket surrounding the PC
screen is flush against the panel surface.
3. Insert the mounting clips into the slots provided around the perimeter of the rear of the
display.
4. Tighten the mounting clips in an even pattern until the PC is firmly held in place. The
screws should be tight enough to slightly deform the gasket. Do not overtighten.
Recommended torque: 3.5 in/lbs.
PC2300 Operations Manual
13
___ 13
Advertisement
Table of Contents
