Reducing The Power Consumption (Eco Mode); Automatic Picture Quality Adjustment Function (Analog Rgb Signal Only) - Sony SDM-S74 Operating Instructions (primary manual) Operating Instructions Manual

Reducing the power consumption
(ECO mode)
If you press the ECO button on the front of the monitor
repeatedly, you can select the screen brightness.
E C O U S E R
ECO
E C O H I G H
,
E C O M I D D L E
E C O L OW
Each mode appears on the screen and the screen brightness is
reduced according to the mode. The menu automatically
disappears after about 5 seconds.
Screen brightness and power consumption are reduced as the
mode changes from HIGH to MIDDLE to LOW.
The default setting of the screen brightness is set to USER.
If you select USER, you can adjust the backlight level by pressing
the m/M buttons, the same as when you select BACKLIGHT
using the menu.
NOTE
Only while the ECO mode is set to USER, are the BACKLIGHT,
CONTRAST, and BRIGHTNESS items of the menu available (page 12).
Automatic picture quality
adjustment function (analog RGB
signal only)
When the monitor receives an input signal, it
automatically adjusts the picture's position and
sharpness (phase/pitch), and ensures that a clear
picture appears on the screen.
The factory preset mode
When the monitor receives an input signal, it automatically
matches the signal to one of the factory preset modes stored in the
monitor's memory to provide a high quality picture at the center
of the screen. If the input signal matches the factory preset mode,
the picture appears on the screen automatically with the
appropriate default adjustments.
:
5 0
:
:
:
If input signals do not match one of the factory
preset modes
When the monitor receives an input signal that does not match one
of the factory preset modes, the automatic picture quality
adjustment function of this monitor is activated to ensure that a
clear picture always appears on the screen (within the following
monitor frequency ranges):
Horizontal frequency: 28–80 kHz (SDM-S74/SDM-S94)
Vertical frequency: 48–75 Hz (SDM-S74/SDM-S94)
Consequently, the first time the monitor receives input signals
that do not match one of the factory preset modes, the monitor
may take a longer time than normal to display the picture on the
screen. This adjustment data is automatically stored in memory so
that next time, the monitor will function in the same way as when
the monitor receives the signals that match one of the factory
preset modes.
If you adjust the phase, pitch, and picture position
manually
For some input signals, the automatic picture quality adjustment
function of this monitor may not completely adjust the picture
position, phase, and pitch. In this case, you can set these
adjustments manually (page 13). If you set these adjustments
manually, they are stored in memory as user modes and
automatically recalled whenever the monitor receives the same
input signals.
Note
While the automatic picture quality adjustment function is activated, only
the 1 (power) switch will operate.
GB
17