Interrupt Selection Jumper (W9) - IBM RT PC Options Installation

TNL SN20-9864 (May 1987) to 75X0217
Interrupt Selection Jumper (W9)
Set the interrupt level of the Interrupt Selection Jumper to any of
the available interrupt levels except interrupt 6, which is used by the
diskette drives. If you are using two Baseband Adapters, ensure that
different interrupt levels have been selected. See "Adapter Conflicts" on
page 1-19.
Note: The factory setting for this jumper is interrupt 9.
6-12 Options Installation
DDc:::::JD~CJD
c:::::JD~CJCJDCJ
c::J
c:::::J c:::::J
c:::J
CJ
c:::::J
c:::J
Di
00
c::::J c:::::J c:::::J c:::::J
~
c:::J
a =
c:=:J=o====D.
15-Pin
May be labeled
2 on adapter