Electrical Connections - Raypak Residential Series Owner's Manual

ELECTRICAL CONNECTIONS

WARNING! – ALL ELECTRICAL WORKS MUST BE COMPLETED BY AN QUALIFIED ELECTRICIAN
Warning: This heater may be coupled to two sources of 240V AC power. Isolate all power sources prior to commencing any
installation, service, or other work. See also warnings included on the heater.
POWER CONNECTION(S)
The heater includes a loosely coiled 3-pin 240VAC power lead for connection to a mains power 10A Waterproof GPO. This
connection is required for operation of the heater.
The heater should be properly connected to a GPO that is suitable for either indoor or outdoor use. Prior to connection inspect the
supplied power connection lead for any damage.
DO NOT connect the heater to any power source if there is any sign of damage.
Where two 240VAC connections are to be made it must be ensured that both operate of the same supply phase.
FLUE DILUTION KIT & EXTERNAL THIRD PARTY POOL CONTROLS
Models P0200, P0280, P0350, P0430, PC0280 & PC0430 Only
These models include a second terminal strip, which enables connection of the optional Dilution Fan Kit (for Indoor installations only)
and an external thermostat control (see figure below).
The Dilution Fan Kit is installed as shown in the wiring diagram supplied with the kit, between terminals A1 and A2, after removing
the corresponding link.
To install an external thermostat control, remove the link between terminal 1 and 2 and connect the thermostat between the terminals
(voltage-free, normally-closed contacts only).
External Controls
Terminal Strip
Page 18 of 32