Step 3: Turn On The Monitor And Computer; Selecting The On-Screen Menu Language (Language) - Sony Trinitron CPD-G220R Operating Instructions Manual

Step 3: Turn on the monitor and
computer
First turn on the monitor, then turn on the computer.
The installation of your monitor is complete.
If necessary, use the monitor's controls to adjust the picture.
If no picture appears on your screen
• Check that the monitor is correctly connected to the computer.
• If NO INPUT SIGNAL appears on the screen, confirm that the
video signal cable is properly connected and all plugs are firmly
seated in their sockets.
• If MONITOR IS IN POWER SAVE MODE appeared on the
screen, try pressing any key on the computer keyboard.
• If you are replacing an old monitor with this model and OUT
OF SCAN RANGE appears on the screen, reconnect the old
monitor. Then adjust the computer's graphic board so that the
horizontal frequency is between 30 – 85 kHz, and the vertical
frequency is between 48 – 170 Hz.
For more information about the on-screen messages, see "Trouble
symptoms and remedies" on page 13.
Setup on Various OS (Operating System)
This monitor complies with the "DDC" Plug & Play standard and
automatically detects all the monitor's information. No specific driver
needs to be installed to the computer.
If you connect the monitor to your PC, and then boot your PC for the first
time, the setup Wizard may be displayed on the screen. Click on "Next"
several times according to the instructions from the Wizard until the Plug
& Play Monitor is automatically selected so that you can use this monitor.
Adjusting the monitor's resolution and color number
Adjust the monitor's resolution and color number by referring to your
computer's instruction manual. The color number may vary according to
your computer or video board. The color palette setting and the actual
number of colors are as follows:
• High Color (16 bit) t 65,536 colors
• True Color (24 bit) t about 16.77 million colors
In true color mode (24 bit), speed may be slower.
Selecting the on-screen menu
language (LANGUAGE)
English, French, German, Spanish, Italian, Dutch, Swedish,
Russian and Japanese versions of the on-screen menus are
available. The default setting is English.
1
Press the MENU/OK button.
See page 9 for more information on using the MENU/OK
button.
MENU
2
Move the joystick m/M to highlight
and press the MENU/OK button.
b
3
Move the joystick m/M to select a language.
L ANGUAGE
ENGL I SH
FRANÇA I S
b
DEUT SCH
ESPAÑOL
I T A L I ANO
NEDER L ANDS
SVENSKA
To close the menu
Press the MENU/OK once to return to the main MENU, and twice to
return to normal viewing. If no buttons are pressed, the menu closes
automatically after about 30 seconds.
LANGUAGE
MENU
US
MENU
7