Self-Diagnosis Function; Specifications - Sony Trinitron CPD-G220R Operating Instructions Manual

Self-diagnosis function

This monitor is equipped with a self-diagnosis function. If there is
a problem with your monitor or computer, the screen will go
blank and the 1 (power) indicator will either light up green or
flash orange. If the 1 (power) indicator is lit in orange, the
computer is in power saving mode. Try pressing any key on the
keyboard.
If the screen is blank and the 1 (power) indicator
is green
1
Disconnect the video input cable or turn off the
connected computer.
2
Press the 1 (power) button twice to turn the monitor
off and then on.
3
Move the joystick , for 2 seconds.
If all four color bars appear (white, red, green, blue), the monitor
is working properly. Reconnect the video input cable and check
the condition of your computer.
If the color bars do not appear, there is a potential monitor failure.
Inform your authorized Sony dealer of the monitor's condition.
If the 1 (power) indicator is flashing orange
Press the 1 (power) button twice to turn the monitor off
and then on.
If the 1 (power) indicator lights up green, the monitor is working
properly.
If the 1 (power) indicator is still flashing, there is a potential
monitor failure. Count the number of seconds between orange
flashes of the 1 (power) indicator and inform your authorized
Sony dealer of the monitor's condition. Be sure to note the model
name and serial number of your monitor. Also note the make and
model of your computer and video board.
MENU
1 (power) indicator

Specifications

CRT 0.24 mm aperture grille pitch (center)
17 inches measured diagonally
90-degree deflection
FD Trinitron
Viewable image size Approx. 328 242 mm (w/h)
(13 9
Viewing image 408 mm (16.1 inches)
Resolution
Maximum Horizontal: 1600 dots
Vertical: 1200 lines
Recommended Horizontal: 1024 dots
Vertical: 768 lines
Standard image area Approx. 312 234 mm (w/h)
(12
Deflection frequency* Horizontal: 30 to 85 kHz
Vertical: 48 to 170 Hz
AC input voltage/current 100 to 240 V, 50/60 Hz, Max. 1.7 A
Power consumption 115 W
Dimensions Approx. 402 418 421 mm (w/h/d)
(15
Monitor weight Approx. 19 kg (41.9 lb)
Plug and Play DDC2B/DDC2Bi/GTF
Supplied accessories See page 6
For CPD-G220S model only
Audio Input Input Impedance: 47 k
Input Level: 0.5 Vrms (typical)
Input Connector Stereo mini jack
Headset Output Output Level: 1.5 mW + 1.5 mW
(RL: 16 W/Input: 0.5 Vrms)
Output Connector Stereo mini jack
Speaker Output 0.5 W (Max.)
* Recommended horizontal and vertical timing condition
• Horizontal sync width should be more than 1.0 µsec.
• Horizontal blanking width should be more than 3.0 µsec.
• Vertical blanking width should be more than 500 µsec.
Design and specifications are subject to change without notice.
5
/ inches)
8
3 1
/ 9 / inches)
8 4
7 1 5
/ 16 / 16 / inches)
8 2 8
15
US