Tuning Software - Protuner; Introduction; Connections And Testing - Motion DMD870 User Manual

DMD870 Digital Stepper Drive

13. TUNING SOFTWARE - PROTUNER

This section will provide an overview of connection and basic setup instructions for our digital
stepping Drive DMD870 using the ProTuner software. These instructions will take you
through the following steps on how to set up your DMD870 stepper drive and the motor with
the software called ProTuner.

Introduction

The ProTuner is a Windows-based setup software for tuning all our DMD series digital
drives includes stepper drive DMD870. It can run in Windows systems, including
Win95/Win98/WindowsNT/ Windows 2000/Windows XP. And the selected PC should have
at least 1 serial port to communicate with the drive.
How to Install ProTuner:
Double click "ProTuner_All_Setup_V1.0.exe" to begin the ProTuner. Click Next to
enter the "License Agreement" window. Choose "I agree to the terms of this license
agreement" and click Next to continue the installation. The user can enter user's
information in the relevant fields. After entering the user's information, click Next to
select installation folder, where you would like to install the ProTuner. Set the
"Shortcut Folder" as the next step and then click Next, an Installation Successful
window will appear if the ProTuner is installed successfully.

Connections and Testing

Connect the stepping system according to the contents in previous sections and connect
the PC to the Drive as the following figure.
Motion Control Products Ltd.
User's Manual
P a g e | 1 9 www.motioncontrolproduts.com