Example Of Configuration; Battery Type; Reset To Factory Pre-Set Configuration - opti-solar SC-Max series User Manual

7.7 Example of configuration

7.7.1 Battery type

By pressing the MENU key, you leave the online status display and go to the main menu. By pressing the key
below the corresponding abbreviation: Conf (System module settings), Prog (System parameter settings) , Load
(Load mode settings) and Logg (Inquiry of internal data logger), you can enter the corresponding menu. In the
case of this example you have to press the first key from left (labelled▲), which is below the abbreviation Conf.
This is how you get into the window for programming the Battery type (Figure 6: Change the battery type).
Note: If you have pressed the wrong key by accident, press MENU to get back to the main menu and
start all over again.

7.7.2 Reset to Factory Pre-Set Configuration

In the previous section, it is described how to enter the window Battery type. The next window up (press ▲) is for
resetting the solar charge controller to the factory pre-set configuration (Factory adjust). By pressing OK you can
enter the Factory adjust window. The instruction to press the MENU key plus the OK key appears immediately.
Only by pressing both of these keys simultaneously will the factory pre-set configurations be set. Then the second
line shows "Done", means successfully restore the factory settings (Figure 7: Reset to Factory Pre-Set
configuration).
88% 12.7
I accu =
Conf
Battery type
OK
Battery type
Liquid
OK
Battery type
Gel
OK
Battery type
Liquid
OK
Figure 6: Change the battery type
Note: 1. If you want to make sure that you have programmed correctly, press only OK and move through all
submenu items to check the values. Do not press the arrow keys while checking, or you will change the values.
2. If you have programmed a wrong value, you will reach the window with the undesired value again and press
OK to change the value to the correct one by pressing the arrow keys▲▼.
26 18
8.3A
OK MENU
Load
Prog Logg
OK MENU
MENU
MENU
MENU
MENU
Page10/13 Pages
88% 12.7
I accu =
Conf
Battery type
OK MENU
Factory adjust
OK MENU
Factory adjust
Press OK+MENU
OK MENU
Factory adjust
Done
OK MENU
Figure 7: Reset to Factory Pre-Set configuration
26 18
8.3A
MENU
OK
Load
Prog Logg
MENU
OK