Table of Contents
Advertisement
Night time 1 settings: Press the OK button to enter the menu, press ▲ ▼ to change the
value.
Night timer 1
When the "Load control" is set to "Timer", "Night timer 1" is the first part light on time when
00:00
dusk coming. If set to "Auto" or "Standard", "Night timer 1" setting is invalid.
Possibilities for programming: 00:00~09:00 (Interval 15min,Default: 00:00).
Night time 2 settings: Press the OK button to enter the menu, press ▲ ▼ to change the
value.
Night timer 2
When the "Load control" is set to "Timer", "Night timer 2" is the second part light on time
00:00
before dawn. If set to "Auto" or "Standard", "Night timer 2" setting is invalid.
Possibilities for programming: 00:00~09:00 (Interval 15min,Default: 00:00).
7.6 Menu Logg (
Inquiry of internal data logger
Press MENU button to enter the menu, you can recall stored data values from today to the last 7 days, at the
same time you can view the accumulated value in and out of the system since the controller installed.
From this menu window, you can read the actual daily value of amp-hours in and out of the
system. Press OK to toggle the display from today's current running data values to the
Day
in
100
stored data values for the last 7 days. You can choose the desired day to view with the
Ah
out
80
arrow key ▲▼. The values can not be changed.
Day 1 in
120
days ago. When a new day of logging starts, the data for each of "Day" to "Day 6" will be
Ah
out
90
shifted to the previous day, i.e. the 7th day data will be replaced with the data for the 6th
day, 6th day replaced by 5th day, etc.
View the accumulated value in and out of the system since the controller installed, this
Total
in
1200
data can not be changed.
KAh
out
880
Note: The minimum value is 1KAh.
Note: All historical data will be deleted only when the device been reset to factory settings.
Note: "Day" simply stands for today and "Day 1"for the day before, "Day 2" means two
Page9/13 Pages
)
Advertisement
Table of Contents
