Installation; Storing Accessories - Makita 2704N Instruction Manual

12. Some dust created from operation contains
chemicals known to cause cancer, birth
defects or other reproductive harm Some
examples of these chemicals are:
— lead from lead-based-painted material
and,
— arsenic and chromium from chemical-
ly-treated lumber.
Your risk from these exposures varies,
depending on how often you do this type
of work. To reduce your exposure to these
chemicals: work in a well ventilated area and
work with approved safety equipment, such as
those dust masks that are specially designed
to filter out microscopic particles.
13. Always make sure that sub guard is down and
flat against saw-table before plugging in the
tool.
14. Inspect extension cords periodically and
replace if damaged.
15. (For European countries only)
Use only saw blades recommended by the
manufacturer and which conform to EN847-1.

INSTALLATION

Positioning table saw
525 mm
► 1. Hole diameter 8 mm
1
25 mm
2
► 1. 6 mm Std. washer 2. No.10 wood screw 40 mm
min. length
► 1. 6 mm Std. washer 2. 6 mm Mounting bolt & Nut
Locate the table saw in a well lit and level area where
you can maintain good footing and balance. It should
be installed in an area that leaves enough room to
easily handle the size of your workpieces. The table
saw should be secured with four screws or bolts to the
work bench or table saw stand using the holes provided
in the bottom of the table saw. When securing the table
saw on the work bench, make sure that there is an
opening in the top of the work bench the same size as
the opening in the bottom of the table saw so the saw-
dust can drop through.
If during operation there is any tendency for the table
saw to tip over, slide or move, the work bench or table
saw stand should be secured to the floor.
620 mm
1
► 1. Miter gauge
6 ENGLISH
1
tighten securely

Storing accessories

2
1