Table of Contents
Advertisement
Chapter 2 Controller Connections/Components
Mini USB Data Connector
Caution MLOG Controller software (SFL-1082-XXX) must be installed on your system PC
before initial use. Remove the yellow label to access the MLOG Controller's mini USB port.
The MLOG Controller is setup and powered through a mini USB data cable.
To connect the mini USB data cable
1. Connect the MLOG Controller power/data cable (mini USB) to the MLOG Controller
as shown.
2. Plug the USB connector end into an open USB port on the PC with MLOG Controller
desktop software loaded (ships with the MLOG Controller).
While the MLOG Controller is connected to the computer, the Controller recharges its
internal battery. Keep the Controller connected for approximately 6 hours to fully recharge
the battery.
8
TDC-0796-001 MLOG Controller User Guide
Advertisement
Table of Contents
