Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ITRON MLOG
Summary of Contents for ITRON MLOG
- Page 1 Water Loss Management Solutions MLOG Controller User Guide TDC-0796-001...
- Page 2 Transportation Classification The Federal Aviation Administration prohibits operating transmitters and receivers on all commercial aircraft. When powered, MLOG Controllers are considered operating transmitters and receivers and cannot be shipped by air. All product returns must be shipped by ground transportation.
-
Page 3: Table Of Contents
MLOG Controller Accessories ......................9 Chapter 3 Operating the MLOG Controller..............11 Power management .......................... 11 Reading MLOGs in the field......................12 Radio Range of the MLOG Controller ....................13 Itron Recommended MLOG Radio-Logger Mounting ............14 TDC-0796-001 MLOG Controller User Guide... - Page 4 Contents TDC-0796-001 MLOG Controller User Guide...
-
Page 5: Chapter 1 Introduction
H A P T E R Introduction The MLOG Controller collects data from field-installed MLOG Radio-Loggers and transfers that data to mlogonline™ Network Leak Monitoring System for analysis. This guide describes the components and use of the MLOG Controller. TDC-0796-001 MLOG Controller User Guide... -
Page 6: Document Conventions
Tip A tip provides the user with extra hints to make a task easier to perform or a concept easier to understand. Note A Note supplies generic information to the user. The information could be ignored and the user could continue with a task without suffering any adverse consequences. TDC-0796-001 MLOG Controller User Guide... -
Page 7: Chapter 2 Controller Connections/Components
5 dB are strictly prohibited for use with this device. The required antenna impedance is 50 ohms. Failure to use an Itron-approved and supplied antenna with the MLOG Controller will also void the warranty. -
Page 8: Mini Usb Data Connector
1. Connect the MLOG Controller power/data cable (mini USB) to the MLOG Controller as shown. 2. Plug the USB connector end into an open USB port on the PC with MLOG Controller desktop software loaded (ships with the MLOG Controller). -
Page 9: Mlog Controller Accessories
MLOG Controller Accessories MLOG Controller Accessories The MLOG Controller is shipped with an 8" 902 - 928 MHz antenna, USB Power/Data Cable, the MLOG Controller holster, and an MLOG Controller Documentation CD (includes MLOG Controller Software SFL-1082-XXX). Accessories and replacement parts are shown in the MLOG Controller Accessories table. - Page 10 Chapter 2 Controller Connections/Components TDC-0796-001 MLOG Controller User Guide...
-
Page 11: Chapter 3 Operating The Mlog Controller
On a full charge, the Controller operates for approximately 5 days. The Controller only transmits a radio wake-up signal while the rechargeable battery has a charge. Plug the MLOG Controller into a USB data port for approximately 6 hours to recharge. -
Page 12: Reading Mlogs In The Field
Controller to turn the Controller Radio "ON" or "OFF" during the hours of 7 a.m. to 4 p.m. Monday through Friday. When the Controller's radio power is on, the MLOG Controller will continuously listen for a beacon from MLOG Radio-Loggers in range. The Controller's radio, if switched on, has an active window of 7:00 a.m. -
Page 13: Radio Range Of The Mlog Controller
• Battery Charging Indicator The MLOG Controller has a rechargeable battery. It takes up to 6 hours to fully charge (or recharge) the battery. While the battery is recharging, the battery charging indicator flashes in sequence as the darkened box moves from right to left (spending approximately two seconds in each box). -
Page 14: Itron Recommended Mlog Radio-Logger Mounting
Chapter 3 Operating the MLOG Controller Itron Recommended MLOG Radio-Logger Mounting TDC-0796-001 MLOG Controller User Guide...