CycleOps PowerBeam Pro User Manual page 15

"UI Data" turns the backlight on when data is re-
ceived from the resistance unit or when buttons are
pressed on the CycleOps PowerBeam
puter. "UI" turns the backlight on only when buttons
are pressed. "OFF" never turns backlight on. Note that
your batteries will have a longer life when the back-
light is used less.
5.4.3 Sleep Time
This function allows you to set the amount of time
the CycleOps PowerBeam
without any activity before it goes into power-saving
sleep mode. Use the arrow buttons to increase or
decrease the number of minutes and press select to
choose it. Again, a shorter time before entering sleep
mode results in increased battery life.
5.4.4: MPH-KPH
This option allows you to choose how you would like
the speed and distance displayed. You can
choose English (miles and miles/hour) or metric
(kilometers and kilometers/hour). Use the arrow
buttons to highlight the units you prefer and press
select to choose it.
5.5: Device ID
This option allows you to manually set which devices
are paired to the CycleOps PowerBeam
puter. A unique number identifi es which resistance
unit, chest strap, and cadence sensor is currently
paired with the CycleOps PowerBeam
puter. Use the arrow buttons to highlight the options
and press select to choose it.
For each of the devices, (i.e., resistance unit, chest
strap and cadence sensor) you can manually enter
the ID number. Use the arrow buttons to enter the
number and the select button to go to the next char-
acter. After the last character, the "learn" modes are
displayed. With the learn mode fl ashing, press and
hold select to perform the function. When a device is
found, the unique ID is displayed.
There are two learn options for the chest strap and
cadence sensor. Learn 1 is used when you have a
new sensor or CycleOps PowerBeam
and there are no like sensors within a 30 foot radius.
Learn 2 is used if there are other like devices in the
area. Note this requires you to remove and re-insert
TM
Pro com-
TM
Pro computer waits
TM
Pro com-
TM Pro com-
TM
Pro computer
the battery in the sensor before activating the learn
2 process. After the battery is re-inserted there is
only a 2 minute window to pair using learn 2.
The resistance unit learn function has the same basic
logic as above, but only offers learn 2 to avoid having
two CycleOps PowerBeam
ling a single resistance unit.
To pair a CycleOps PowerBeam
resistance unit, simply use learn 2. The power to the
resistance unit must be cycled by unplugging the
unit from the electrical supply.
The CycleOps PowerBeam
an automatic learn 2 function for the resistance unit.
When the "Resist Unit" ID is set to zeros (00000), the
CycleOps PowerBeam
cally pair to the fi rst available resistance unit after
entering the ride or workout screen.
Note: When the battery is removed and re-inserted in
the heart rate strap or the cadence sensor, you must
re-learn them to the CycleOps PowerBeam
puter . Changing the battery resets the strap.
Pressing "Reset" will reset all the device IDs to zeros.
5.6: Test
This option allows you to perform tests on your
CycleOps PowerBeam
operational status. Use the arrow buttons to scroll
down to the option you desire and press select to
choose it.
5.6.1 About
This screen displays the version number for the
fi rmware running on the CycleOps PowerBeam
Pro computer and the Saris Cycling Group customer
TM
Pro computers control-
TM
Pro computer and
TM
Pro computer also has
TM Pro computer will automati-
TM
TM Pro unit to help determine
Pro com-
TM
11