Jeep Wrangler TJ 2006 Diagnostic Manual page 66

AIRBAG
PASSENGER OFF INDICATOR CIRCUIT SHORT TO GROUND —
TEST
3 Is this vehicle equipped with a Passenger Airbag On - Off Switch?
Yes → Go To 4
→ With the DRBIII in MISCELLANEOUS, read the Configure for
No
4 Gain access to the Passenger Airbag On - Off Switch connector.
Is the Passenger Airbag On - Off Switch connected to the dash harness?
Yes → Go To 5
→ Connect the Passenger Airbag On - Off switch to the dash harness
No
5 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN IGNITION
OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BEFORE
PROCEEDING.
Disconnect the Passenger On - Off Switch connector.
NOTE: Check connectors - Clean and repair as necessary.
WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN IGNITION
ON, THEN RECONNECT THE BATTERY.
Measure the voltage on the Fused Ignition Switch Output Run - Start circuit between
the PAB On - Off Switch connector and ground.
Is the voltage above 10.0 volts?
Yes → Go To 6
→ Repair the open Fused ignition Switch Output Run - Start circuit.
No
6 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Passenger Airbag On - Off Switch.
NOTE: Check connectors - Clean and repair as necessary.
Measure the resistance between PAB On - Off Switch terminals 3 and 4.
Is the resistance approximately 14 ohms?
Yes → Go To 7
→ Replace the Passenger Airbag ON - OFF Switch in accordance
No
ACTION
Airbag ON - OFF Switch current status. Enter the number 1 and
press enter to re configure the ACM for NO AIRBAG ON/OFF
SWITCH.
Perform __AIRBAG VERIFICATION TEST - VER 1.
connector.
Perform __AIRBAG VERIFICATION TEST - VER 1.
Perform __AIRBAG VERIFICATION TEST - VER 1.
with the service information.
Perform __AIRBAG VERIFICATION TEST - VER 1.
60
Continued
APPLICABILITY
All
All
All
All