Passenger Off Indicator Circuit Short To Ground - Jeep Wrangler TJ 2006 Diagnostic Manual

Symptom:

PASSENGER OFF INDICATOR CIRCUIT SHORT TO GROUND

When Monitored and Set Condition:
PASSENGER OFF INDICATOR CIRCUIT SHORT TO GROUND
When Monitored: With the ignition on, the ACM monitors the PAB Indicator Driver
circuit for voltage from the PAB On - Off Switch indicator circuit.
Set Condition: The code will set if the ACM cannot detect voltage on the PAB Indicator
Driver circuit.
ACTIVE ACM RUN - START CODES
CHECKING EQUIPMENT
FUSED IGNITION SWITCH OUTPUT RUN - START
SWITCH DISCONNECTED
PAB ON - OFF INDICATOR OPEN
PASSENGER AIRBAG INDICATOR DRIVER CIRCUIT OPEN
PASSENGER AIRBAG INDICATOR DRIVER CIRCUIT SHORT
ACM, PASSENGER ON - OFF INDICATOR CIRCUIT OPEN
STORED CODE OR INTERMITTENT CONDITION
ACTIVE CODE PRESENT
TEST
1 Turn the ignition on.
NOTE: Ensure that the battery is fully charged.
NOTE: For the purpose of this test, the AECM and ORC modules will be
referred to as an ACM.
SELECT ACTIVE or STORED DTC:
ACM - ACTIVE DTC
ACM - STORED DTC
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
2 With the DRBIII , read active Airbag Control Module DTC's.
Does the DRBIII display LOSS OF IGNITION RUN - START ?
Yes → Refer to symptom list for problems related to Loss of Ignition Run
→ Go To 3
No
POSSIBLE CAUSES
ACTION
Go To 2
Go To 10
- Start active diagnostic trouble code test.
Perform __AIRBAG VERIFICATION TEST - VER 1.
59
AIRBAG
APPLICABILITY
All
All