Makita HM1202 Technical Information page 8

< 6> Mounting of barrel
Take off only handle, not remove controller cover.
(1) Set the of the guide ring on the
Mount the above guide ring and flat washer 49 on the 3 prongs
of slide sleeve 49.
(2) Set collared ring 24 ,rubber ring 25 and impact bolt guide
on the 3 prongs of slide sleeve 49.
(3) Set barrel (with tool holder) on the cylinder liner 44 gently paying attention
to keep rubber ring 25 and impact bolt guide on the slide sleeve's edge.
Mount compression spring 50 on crank housing by pressing it.
< Remarks>
Pay attention to the position of flat part on barrel as per the following illustration.
Tool holder
Flat part on barrel
has to face in the direction
of top and bottom.
Collared
sleeve 24
< 7> Mounting of controller cover
Set switch trigger in
of flat washer 49.
Barrel
Impact bold guide
Rubber ring 25
Cylinder liner 44
Crank housing
of switch lever.
Guide ring
Flat washer 49
Slide sleeve 49
Compression spring 50
P 8 / 14