Makita HM1202 Technical Information page 13

Circuit diagram
HM1202C with controller
Lead wire "r1(Red)" has to be guided
through rib A as per the
illustration.
Lead wire from field (F1.Black)
and (F2. White) has to be fixed
by lead holder as per the illustration.
Lead wires of pick up coil have to
be guided through rib B.
At this time these 2 lead wires have not
to be crossed each other.
Every lead wires have to be
set in the space between rib D
and rib E.
Rib A
Cord from power supply
cord has to be set in
the groove.
Controller
Rib D
Rib E
Lead wire "r1"(red)
Lead wire "r2. black" and
"r3. white" have to be set
in the groove as per the
illustration.
Boss A
Cord from power supply cord,
Rib C
lead wire "r2. black" and
"r3. white" have to be
set in the groove on the right side
of controller.
Cord from power supply cord,
lead wire "r2. black" and
"r3. white" have to be
Boss B
guided through the space
between boss B and rib D.
P 13 / 14
F2. White
F1.Black
Rib B
Cord from power supply cord,
lead wire "r2. black" and
"r3. white" have to be guided
through the space between boss A
and rib C.