Default Setting Values - Emerson Dixell XR75CX Series Installation And Operation Manual

19 Default Setting Values

Label
SEt Setpoint
HY Differential
LS Minimum setpoint
US Maximum setpoint
ot Thermostat probe calibration
P2P Evaporator probe presence
oE Evaporator probe calibration
P3P Third probe presence
o3 Third probe calibration
P4P Fourth probe presence
o4 Fourth probe calibration
odS Outputs delay at start up
AC Anti-short cycle delay
rtr P1-P2 percentage for regulation
CCt Continuous cycle duration
CCS Setpoint for continuous cycle
Compressor ON time with faulty
Con
probe
Compressor OFF time with faulty
CoF
probe
CF Temperature measurement unit
rES Resolution
Lod Probe displayed
2
X-REP display
rEd
dLY Display temperature delay
dtr P1-P2 percentage for display
tdF Defrost type
Probe selection for defrost
dFP
termination
Table 19-1- XR75CX Default Setting Values (
26 • XR75CX I&O Manual
Name
2
Only for XR75CX with X-REP output)
Range
LS to US
[0.1 to 25.5°C]
[1 to 255°F]
[-50°C to SET]
[-58°F to SET]
[SET to 110°C]
[SET to 230°F]
[-12 to 12°C]
[-21 to 21°F]
n=not present; Y=pres.
[-12 to 12°C]
[-21 to 21°F]
n=not present; Y=pres.
[-12.0 to 12.0°C]
[-21 to 21°F]
n=not present; Y=pres.
[-12.0 to 12.0°C]
[-21 to 21°F]
0 to 255 min
0 to 50 min
0 to 100 (100=P1, 0=P2)
0.0 to 24h 00min, res. 10min
[-50 to 110.0°C]
[-58 to 230°F]
0 to 255 min
0 to 255 min
°C; °F
in=integer; dE= dec.point
P1; P2
P1; P2; P3; P4; SEt; dtr
0.0 to 20min 00s, res. 10s
1 to 99
EL=el. heater; in= hot gas
nP; P1; P2; P3; P4
Value Level
[-5.0°C]
- - -
[23°F]
[2.0°C]
Pr1
[2°F]
[-50.0°C]
Pr2
[-58°F]
[110.0°C]
Pr2
[230°F]
[0.0°C]
Pr1
[0°F]
Y Pr1
[0.0°C]
Pr2
[0°F]
n Pr2
[0.0°C]
Pr2
[0°F]
n Pr2
[0.0°C]
Pr2
[0°F]
0 Pr2
1 Pr1
100 Pr2
0.0 Pr2
[-5°C]
Pr2
[23°F]
15 Pr2
30 Pr2
[°C] [°F] Pr2
dE Pr1
P1 Pr2
P1 Pr2
0.0 Pr2
50 Pr2
EL Pr1
P2 Pr2
026-1210 Rev 4