UP1500 User's Manual
5.2.3
Error Recovery Procedure
51-0048-1B
Table 5-2
Switch Settings for Various Error Conditions
Error
Factory Default
Reload Firmware
To clear the errors noted in section 5.2.1, take the following steps:
1. Power off the system.
2. Change the SW1 switch settings according to the error to be cleared.
3. Start the system.
4. Enter the proper parameters in SRM Console.
5. Load the Operating System.
6. Power off the system.
7. Restore the SW1 switches to their default positions.
8. Start the system.
Function
Boot under SRM
800MHz
Console
Reload SRM Console
from FSB
Chapter 5 Troubleshooting
SW1 Switch:
1
2
On
On
Off
Off
5-4