Ew*0_Mode Options - Samsung UP1500 800-A1 User Manual

UP1500 User's Manual
console
ew*0_mode
UP1500 800-A1
Example 4-12 Using com*_baud
>>> set com1_baud 19200
Embedded Remote Console only supports 9600 baud. Continue?
(Y/[N]) n
bad value - com1_baud not modified
>>>
The operator console terminal can be either a graphics monitor or a serial
terminal. The console environment variable specifies which is used. The syntax
is:
set console output_device
The options for output_device are:
graphics
(default)
serial
Whenever you change the value of console, you must reset the system by
pressing the Reset button or issuing the initialize command.
Sets an Ethernet controller to run an Ethernet network. The default value is
auto-sense. For the fast setting, the device defaults to fast.
The syntax is:
set ew*0_mode value
The options for value are shown in Table 4-11.
Table 4-11 ew*0_mode Options
Option
aui
auto-sense
twisted-pair
fast duplex,
twisted-pair
fast
fastFD
BNC
auto-negotiate
The operator console terminal is a graphics monitor or a device
connected to the VGA or TGA module.
The operator console terminal is the device connected to the
COM2 port.
Device type is AUI.
Device type is sensed by the SRM Console.
Device type is 10BaseT (twisted pair).
Device type is duplex 10BaseT
Device type is fast 100Base TX
Device type is fast full duplex 100Base TX
Device type is BNC
DE500-BA provides auto-sensing capabilities
Chapter 4 Software Support
Description
4-18