UP1500 User's Manual
5.2
Error Recovery Procedures
5.2.1
Error Conditions
Restore Factory
Defaults
Reload Firmware
5.2.2
Error Recovery Switch Settings
51-0048-1B
On the UP1500 switchpack SW1, two configuration switches with selectable
settings are firmware-related. They are identified by the shaded box in Figure 5-2.
You can change the configuration settings to recover from several error
conditions.
Figure 5-2
Firmware Configuration Switches
In addition to the factory default setting, there are two other configuration settings
which you select based on certain error categories.
Some error conditions of this type include:
!
Choosing incorrect selections when configuring the SRM Console. These
selections prevent the system from booting.
!
Forgetting your system password.
An error condition of this type may occur during the upgrading of the SRM
Console by an improper system action. An example would be: accidentally
powering off the system during this procedure.
For more information, see the FAQs on the Alpha web site:
http://www.alpha.samsung.com
For these error recoveries, select the appropriate settings from Table 5-2.
1
SW1
Chapter 5 Troubleshooting
8
On
Off
5-3