H3C S5510 Series Operation Manual page 9

Operation Manual – Cluster Management
H3C S3610&S5510 Series Ethernet Switches
Complete these tasks to configure a cluster:
Configuring the
Management
Device
Configuring the
Member Devices
Configuring Access Between the Management Device and Its
Member Devices
Adding a Candidate Device to a Cluster
Configuring
Advanced
Cluster
Functions
Caution:
Disabling the NDP and NTDP functions on the management device and member
devices after a cluster is created will not cause the cluster to be dismissed, but will
influence the normal operation of the cluster.
Tasks
Enabling NDP Globally and for Specific Ports
Configuring NDP Parameters
Enabling NTDP Globally and for Specific Ports
Configuring NTDP Parameters
Manually Collecting NTDP Information
Enabling the Cluster Function
Establishing a Cluster
Configuring Communication Between the
Management Device and the Member Devices
Within a Cluster
Configuring Cluster Member Management
Enabling NDP Globally and for Specific Ports
Enabling NTDP Globally and for Specific Ports
Manually Collecting NTDP Information
Enabling the Cluster Function
Deleting a Member Device from a Cluster
Configuring Topology Management
Configuring Interaction for a Cluster
1-8
Chapter 1 Cluster Management Configuration
Remarks
Optional
Optional
Optional
Optional
Optional
Optional
Required
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional