H3C S5510 Series Operation Manual page 26

Operation Manual – Cluster Management
H3C S3610&S5510 Series Ethernet Switches
[aabbcc_0.Switch-cluster] management-vlan synchronization enable
# Configure the holdtime of the member device information as 100 seconds.
[aabbcc_0.Switch-cluster] holdtime 100
# Configure the interval to send handshake packets as 10 seconds.
[aabbcc_0.Switch-cluster] timer 10
# Configure the FTP Server, TFTP Server, Log host and SNMP host for the cluster.
[aabbcc_0.Switch-cluster] ftp-server 63.172.55.1
[aabbcc_0.Switch-cluster] tftp-server 63.172.55.1
[aabbcc_0.Switch-cluster] logging-host 69.172.55.4
[aabbcc_0.Switch-cluster] snmp-host 69.172.55.4
# Add the device whose MAC address is 00e0-fc01-0013 to the blacklist.
[aabbcc_0.Switch-cluster] black-list add-mac 00e0-fc01-0013
[aabbcc_0.Switch-cluster] quit
# Configure the network management interface.
[aabbcc_0.Switch] vlan 2
[aabbcc_0.Switch-vlan2] port Ethernet 1/0/1
[aabbcc_0.Switch] quit
[aabbcc_0.Switch] interface vlan-interface 2
[aabbcc_0.Switch-Vlan-interface2] ip address 163.172.55.1 24
[aabbcc_0.Switch-Vlan-interface2] quit
[aabbcc_0.Switch] cluster
[aabbcc_0.Switch-cluster] nm-interface vlan-interface 2
Note:
Upon completion of the above configurations, you can execute the cluster
switch-to { member-number | mac-address mac-address } command on the
management device to switch to the operation interface of a member device to
maintain and manage it. You can then execute the quit command to return to the
operation interface of the management device.
You can also reboot a member device by executing the reboot member command
on the management device.
You can execute the cluster switch-to administrator command to switch to the
operation interface of the management device.
For detailed information about these configurations, refer to the preceding
description in this chapter.
Chapter 1 Cluster Management Configuration
1-25