Monaco Executive 2005 Owner's Manual page 109

Troubleshooting:
• Valet/Program is not responding - Ensure the button is
plugged into the blue port of the receiver.
• Red Status LED does not work - Ensure the LED is
plugged into the correct socket.
• Shock Sensor will not trigger alarm - Ensure the Nuisance
Prevention Circuitry system has not triggered.
• System has no power - Ensure the 15 Amp fuse (front run
panel) is not blown.
• System is not responding to remote - Ensure the Valet
mode is not entered.
Changing the Programming - Entering the Learn Routine:
The following information is provided for changing the
programming features and should only be used by an authorized
service center.
1. Open the door.
2. Turn ignition ON, then OFF.
3. For menu selection: Press and hold the Valet/Program but-
ton.
4. Select a feature.
5. Program a feature.
6. Release the Valet/Program button.
When the feature is programmed:
• Other features can be programmed within the same menu.
• Another menu can be accessed.
• The learn routine can be exited.
To access another feature in the same menu:
• Press the Valet/Program button the number of times nec-
essary to advance to the desired feature.
• Press the Valet/Program button and HOLD.
The Executive 2005
2 Channel Receiver
Control Module
Viper Assembly Panel:
Located under the Dash Pod.
Control Module
Valet/Program Button
on main dash panel
near ignition.
Valet/Program button & blue LED status light.
Driving & Safety --- Section 2
Shock
Sensor
020048
020049 front view
Blue LED:
Located on
vinyl Dash.
109