Storage And Maintenance; Replacement Parts - Chapin 80008N Assembly / Operation Instructions / Parts

IMPROPER USE OR FAILURE TO FOLLOW INSTRUCTIONS CAN RESULT IN
PRODUCT FAILURE OR INJURIES. FOR SAFE USE OF THIS PRODUCT YOU
MUST READ AND FOLLOW ALL INSTRUCTIONS BEFORE USING.
Assembly Instructions
• Loosen wing nuts and flip up handle
• Tighten wing nuts completely
General Operating Instructions
• Be sure gate control is in the closed position before filling hopper
• Determine appropriate setting for material being used by reading the suggested setting on the material's bag
AND/OR by referencing the application chart on your spreader's control panel (Charts provided are only
guidelines. Be sure to read the instructions on the bag/box of the material you're spreading to identify accurate
setting needed)
• Remove wing nut and slide indicator to desired setting. Tighten wing nut completely.
• To begin spreading, start walking (about 3mph pace) and push the gate control away from you to open gate
• To stop spreading simply pull the gate control into the closed position

Storage and Maintenance

• When finished spreading empty hopper of any remaining material
• Thoroughly wash spreader and allow to dry before storing
• To fold down handle:
- Loosen wing nuts and flip handle down
- Tighten wing nuts completely

Replacement Parts

Ref.# Qty
1 1
2 1
3 2
* 1
* 1
* 1
* 1
* Not Shown
WARNING
Part No. Description
6-9003 Wheel, Molded 8" (80008N)
6-9004 Axle Cap Driver, Idler (80008N)
6-9005 M6 x 10mm Hex Bolt
6-9006 Wheel, 10" Solid Rubber (80028N)
6-9007 Axle Cap Driver, Idler (80028N)
6-9029 Auger Kit
6-9028 Baffle Kit
Handle
Bolt
2
3
Wing
Nut
3
2
1