Using A Md Walkman Connected To The Computer - Sony MZ-M10 Hi-MD Music Transfer Version 1 for Mac (User Manual) Operating Instructions Manual

Using a MD Walkman connected to the computer

Problem
Your computer does not
recognize the MD Walkman.
Even though the supplied USB
cable is used to connect the
MD Walkman to the computer,
the display on the MD
Walkman does not indicate it is
connected.
Even though your computer
recognize the MD Walkman, it
does not operate normally.
112
Cause/Remedy
The MD Walkman is not firmly connected with the
supplied USB cable to the computer.
tReconnect the MD Walkman to the computer firmly.
tRemove and reconnect the MD Walkman. If the
computer still does not recognize the MD Walkman,
disconnect the cable, restart the computer, and then
make the connection again.
A disc is not inserted in the MD Walkman.
tCheck if a disc is inserted in the MD Walkman.
The Net MD driver is not installed.
tInstall the SonicStage/MD Simple Burner software
using the supplied CD-ROM.
The software installation failed.
tDisconnect the connected device and install the
software again using the supplied CD-ROM.
The supplied USB cable is disconnected.
tConnect the supplied USB cable firmly.
The connections are made through a USB hub.
tOperations are not guaranteed for USB-hub
connections. Connect the MD Walkman directly to
the USB connector on the computer.
It takes time to recognize SonicStage.
tPlease wait.
The other application software is running.
tReconnect the supplied USB cable after a while. If
the computer still does not recognize the MD
Walkman, disconnect the MD Walkman, restart the
computer, and connect the USB cable again.
The supplied USB cable is disconnected.
tConnect the supplied USB cable firmly.
The connections are made through a USB hub.
tOperations are not guaranteed for USB-hub
connections. Connect the MD Walkman directly to
the USB connector on the computer.