Selecting The Disc Mode (Disc Mode); Adjusting The Contrast Of The Display Window (Contrast Adjustment) - Sony MZ-M10 Hi-MD Music Transfer Version 1 for Mac (User Manual) Operating Instructions Manual

Selecting the disc
mode (Disc Mode)
When you insert a 60/74/80-minute
standard disc (blank) into the recorder,
you can use this function to specify use of
the disc in Hi-MD mode or MD mode.
When recording on this recorder without
using a computer, set "Disc Mode" to
"Hi-MD". Recording is not possible if
"Disc Mode" is set to "MD". To allow a
disc recorded on this recorder to be used
on another component that does not
support Hi-MD, set "Disc Mode" to
"MD" and use a Windows computer to
record in MD mode (refer to the
"Software Operation" section).
1
Enter the menu and select "Option" -
"Disc Mode".
2
Turn the jog dial until "Hi-MD"
(factory setting) or "MD" appears in
the display, and then press the dial to
enter the selection.
Notes
•
Even if you select "MD" as the "Disc Mode"
setting, the operation mode can only be "Hi-
MD" when using a 1GB Hi-MD disc.
•
The operation mode set in the "Disc Mode"
menu is applied to a blank 60/74/80-minute
standard disc used on the recorder even if a
different operation mode was selected in the
SonicStage software or a different operation
mode appeared on the display after the disc
was formatted by the SonicStage software.
58
Adjusting the contrast
of the display window
(Contrast Adjustment)
You can adjust the contrast of the display
window.
1
2
MENU
Jog dial
While the recorder is stopped, enter
the menu and select "Option" -
"Contrast".
Turn the jog dial to adjust the
contrast, and then press the dial to
enter the selection.
MENU
Jog dial