Sony MZ-M10 Hi-MD Music Transfer Version 1 for Mac (User Manual) Operating Instructions Manual page 80

Message
READ ERROR
REC ERROR
SEARCH
SYSTEM FILE
WRITING
TEMP OVER
REC STOP
TITLE FULL
TOC DATA
ERROR
TRACK FULL
TRK FROM PC
NO EDIT
TRK FROM PC
NO REC
80
Meaning/Remedy
• The recorder cannot read the disc information correctly.
, Reinsert the disc.
• Recording was not correctly done.
, Place the recorder at a place with no vibrations and record again.
• The disc is soiled with an oil film or finger prints, is scratched, or is not a
standard disc.
, Try recording again with another disc.
• You pressed a button or a control on the remote control while using the
Search function on the recorder.
, Use the buttons and controls on the recorder.
• The recorder is storing information (track start and end position) from the
memory to the disk.
, Wait until this process is completed. Do not expose the player to
physical shock, nor disrupt power supply.
• Heat has built up in the recorder.
, Let the recorder cool down.
• You tried to enter more than 200 letters to label a single track, group, or
disc.
• You tried to enter a total of more than approximately 55,000 letters (in a
disc used in Hi-MD mode) or 1,700 letters (in a disc used inMD mode) for
titles.
• The recorder cannot read the disc information correctly.
, Insert another disc.
, If it is no problem to erase the entire disc, do so (page 53).
• You tried to record more than 2,047 tracks on a disc used in Hi-MD mode.
, Erase unnecessary tracks (page 52).
• You tried to combine or divide tracks that were transferred from the
Windows computer.
, You cannot combine or divide transferred tracks.
• You tried to combine or divide tracks that were recorded in Hi-MD mode
using the MD Simple Burner software.
, You cannot combine or divide tracks recorded in Hi-MD mode with the
MD Simple Burner software.
• You tried to record in the middle of a protected track that has been
transferred from the Windows computer.
• You tried to record in the middle of a track that was recorded in Hi-MD
mode with the MD Simple Burner software.
, You cannot record new material in the middle of a protected track or a
track that was recorded in Hi-MD mode with the MD Simple Burner
software.