Microphone Mute; Inserting A Pause In The Dialed Number; Storing A Number In The Phone Memory; Dialing A Number Stored In The Phone Memory - Binatone ACTIVE XA2020 Instruction Manual

2. Press the LNR/P button [6] and the last dialed number will be
automatically redialed. (You can redial a number consisting of no
more than 32 digits.)

Microphone mute

You can turn off the handset microphone during a call. The calling
party will not hear you.
1. Press the SEC button [4]. (When the microphone is turned off, the
indicator light [2] flashes and the handset buttons are locked.)
2. To cancel the microphone mute, press the SEC button [4] once
again.

Inserting a pause in the dialed number

When saving a phone number in the phone memory, press the
LNR/P button [6] where the pause is needed (if a long pause is
necessary, then press the LNR/P button [6] several times). For example,
if you are dialing through a PBX and should dial '9' to access the PBX
trunk, press the LNR/P button [6] after entering '9' and then enter the
number you want to store.

Storing a number in the phone memory

You can store in the phone memory, 16 phone numbers up to 20
digits each.
1. Press the MEM button [8], the indicator light [2] starts to flash.
2. Enter the number you want to store in the memory.
3. Press the MEM button [8] once again.
4. Enter a two-digit number (01 to 16) under which you want to store
the entered phone number.
5. After completing the above steps you will hear a beep and the
indicator light [2] will go out.

Dialing a number stored in the phone memory

1. Press the PHONE button [3], the indicator light [2] lights up.
2. Press the MEM button [8].
3. Enter the two-digit number (01 to 16) corresponding to the phone
number you want to dial
Note:
You can store in the phone number just a part of a phone number
(for example, the international telephone code) and combine memory
dialing with normal phone number dialing.

Deleting a number stored in the phone memory

1. Press the MEM button [8], the indicator light [2] starts to flash.
2. Press the MEM button [8] once again.
3. Enter the two-digit number (01 to 16) corresponding to the phone
number you want to delete.
4. After completing the above steps you will hear a beep and the
indicator light [2] will go out.

Changing the ringer tone

1. Press the VOLUME/RINGER
be changed during a call), the indicator light [2] lights up.
2. To select the desired ringer tone, press one of the buttons 1...8 .
3. Press the VOLUME/RINGER
indicator light [2] goes out.
button [7] (the ringer tone cannot
button [7] once again, the
9