How To Confirm The Dvs Signal Route - Pioneer DJM-850-K Service Manual

5

5.10 HOW TO CONFIRM THE DVS SIGNAL ROUTE

What is the DVS (Digital Vinyl System)?
The Digital Vinyl System (DVS) enables control of DJ software with normal DJ's operations of the CDJs or turntables, with use
of a control CD or VINYL supplied with DJ software that supports the DVS. A control disc contains timecodes for controlling
DJ software, which enable playback of music files stored on the PC from an assigned playback position at an assigned
playback speed.
Note: For checking operations as the DVS, a control CD (CD on which timecodes are recorded) is required. However,
assuming a case where no control CD is available, a simple check procedure using a music CD is explained here.
Necessary Items
• PC with the USB driver and TRAKTOR (demo version or TRAKTOR DDJ-T1 EDITION possible) installed
Can download the Traktor demo version from the following URL.
http://www.native-instruments.com/#/en/products/dj/traktor-pro-2/?page=1975
• Media (CD, etc.) for checking operations, CDJ player
Check Procedures
1. Connect this unit and a PC, using the USB cable.
2. Connect the audio output of CDJ Player to the CD/LINE of CH1 of this unit.
3. Set the CD/LINE, PHONO, LINE, and USB */* selectors to USB1/2.
4. For details on settings to be made on the PC, see "Settings for the Driver" and "Settings on TRAKTOR" below.
5. Play back the CDJ Player, and check the following items:
• The level meters of Input Routing and Master Out on the TRAKTOR move in sync with audio output signals.
• The Master Out is output normally.
*Repeat the above steps for channels 2 to 4, to check the DVS paths.
Note:
The Master Out signal will not be output if the MAIN volume control is set to the minimum volume position.
If the MAIN volume indicators are not displayed on the screen, set the TRAKTOR screen to Full screen.
[Connection Diagram (When the CDJ Player is Connected to CH1)]
Computers
USB cable
5
6
DJM-850
DJM-850
Power amplifier
DJM-850-K
6
7
7
8
A
B
C
D
E
CDJ player
F
39
8