Rounding (G01) - Wuhan Huazhong Numerical Control Co., Ltd HNC-18iT v4.0 Programming Manual

3.4.2 3.4.2 Rounding Rounding
3.4.2 3.4.2 Rounding

Rounding (G01)

Programming Programming Programming Programming
G01 X(U)_ Z(W)_ R_
Explanation Explanation of of of of the Explanation the the
Explanation the parameters
X, Z Coordinate values of the intersection (point G) in absolute command
U, W Coordinate values of the intersection (pint G) in incremental command
R Radius of the rounding (r)
Function
Function Function Function
A corner can be inserted between two blocks which intersect at a right angle (point A→B→
C).
Note:
Note: Note: Note: The length of GA should be more than the length of GB
(G01) (G01)
(G01)
parameters parameters
parameters
+X +X +X +X
D D D D
z z z z
Figure 3.12 Rounding (G01)
w w w w
A A A A
r r r r
u/2
u/2 u/2 u/2
B B B B
C C C C
G G G G
x/2 x/2
x/2 x/2
39
3. Interpolation Function
+Z +Z +Z +Z