Omnitronic COMBO-150BT User Manual page 27

Lock
Microphone/line input
Combo input (XLR/6.3 mm jack) for
connecting a microphone or an audio unit
with mono line output, for each channel 1 to 4.
Input selector switch
Switches the channels 1 to 4 from
microphone input to line input.
Tone controls
Controls for the high range (TREBLE) and
the low range (BASS), for each channel 1 to 4.
Effect controls
Determines the level at which the channel
signal is fed to the internal effect processor,
for each channel 1 to 4.
Level controls
To mix the channel signal to the master
signal, for each channel 1 to 4.
Clip indication
Lights red in case of overload, for each
channel 1 to 4.
Antenna input
Line input
Stereo input (6.3 mm jack and RCA L/R) for
connecting audio units with line level (e.g.
CD player) for channel 5/6.
Level control channel 5/6
c
Level control audio player
Intensity control
Adjusts the overall intensity of the internal
echo effect.
Recording output
Stereo output (RCA L/R) for the master
signal for connecting the input of a recorder.
Power indicator
Phantom power selector switch
When engaged, a 15 V phantom power is
switched on for all XLR microphone inputs.
Phantom power is a lower DC voltage which
most professional condenser microphones
require.
Clip indication
Lights red if the internal power amplifier
section is overloaded.
Master control
Level control for the master signal sent to the
speaker outputs.
Audio player with LCD and 6
operating buttons
Speaker outputs
6.3 mm jacks, L/R for connecting the left and
right speaker.
Voltage selector switch
Power on/off
Fuse holder
Only replace the fuse when the device is
disconnected from mains. Only use fuses of
the same rating and power.
Power input
Used to plug in the supplied power cord.
27