Setting Of The Number Of Modules - Mitsubishi MELSEC-A Series Reference Manual

7. DATA LINK SETTINGS
7.2

Setting of the Number of Modules

Set the number of the data link modules installed to the AnUCPU, QnACPU,
A2ASCPU(S1), A2USHCPU-S1 or Q2AS(H)CPU(S1) and head I/O numbers etc.
Settings must be made to the master and local stations.
(1) Setting items
(a) Number of network modules
(b) Valid module number for other station access
(c) Head I/O Number
(d) Network module type name
(e) Network No.
Set the total number of the MELSECNET ( ) data link modules and
MELSECNET/10 network modules that are installed to the AnUCPU, QnACPU,
A2US(H)CPU(S1), or Q2AS(H)CPU(S1).
The setting range is 1 to 4.
Note that the number of mountable data link modules is limited to two.
Set which module will be the target of other station access from the peripheral
device (SW4GP-GPPA, SW0SRXV-GPPA, etc.) or special function module
(AJ71C24-S8, AD51H-S3, etc.) incompatible with the AnUCPU, QnACPU,
A2ASCPU(S1), A2USHCPU-S1 or Q2AS(H)CPU(S1).
The setting range is 1 to 4.
Set the head I/O number (first 3 digits of 4-digit hexadecimal) of the data link
module installed.
For example, set "5" if the I/O numbers are X/Y50 to 6F.
*: In GX Developer, set it in 4 digits. In the above example, enter "0050".
Select the type of the data link module installed from the followings.
5: MELSECNET (master station)
6: MELSECNET (local station)
This setting is not required for the MELSECNET .
7 - 2
MELSECNET mode MELSECNET
MELSECNET
MELSECNET
Operating Mode
mode
mode
Applicability
MELSECNET/B
MELSECNET
MELSECNET MELSECNET MELSECNET
composite mode mode mode composite mode