Advertisement
IMPORTANT: Loss of suction may occur if
foam filters are not cleaned every 3 months.
Rinse and allow to air dry completely. Also,
tap loose dirt off filter between washes
as needed. Foam filters may appear dirty
after use - this is normal. Please refer to the
instruction booklet the for instructions on
cleaning the filters.
BRUSHROLL
BRUSHROLL ON
Engage the motorized
floor brush to vacuum
carpets and rugs.
BARE FLOOR
Use to vacuum in Lift-
Away™ mode, to vacuum
bare floors, or to use tools
(straight suction only).
OFF
To engage the brushroll, press
the floor nozzle down with
your foot and tilt the handle
back towards you.
INDICATOR LIGHT
The motorized brush indicator light will illuminate
Green when motorized floor brush is on. If there is a
blockage or jam, the light will turn Red.
UV541CCO_QSG_EN_REV_Mv1
For questions or to register your product visit us online at sharkclean.com ©2018 Shark Operating LLC
USE AND CARE
This vacuum has huge suction power. The suction can
be adjusted to make the vacuum easier to push and
pull on certain types of carpets as needed.
Adjust the amount of suction by rotating the suction
release collar on the handle counterclockwise to
reduce the suction or clockwise for maximum suction.
1 Pull up the latches on the sides of the dust cup
to release.
2 Hold the dust cup over a trash receptacle and
press the bottom door release button.
3 If needed, turn the dust cup upside down over
the trash and press the top door release button.
1 With the dust cup removed, pull
the 2 filters out from the top of the
motor base.
2 Rinse the filters thoroughly in
lukewarm water until the water runs
clear.
3 Squeeze out excess water and let
air-dry for at least 24 hours before
inserting back into the vacuum.
SUCTION CONTROL
EMPTYING THE DUSTCUP
CLEANING FILTERS
Advertisement
