General Information - Lang Electric Clamshell CSE12-208VCD Installation, Operation And Maintenance Instructions

General Information

General Information
Lockout Procedure
Announce lockout to other personnel.
Turn power off at main panel.
Test lockout by turning power switch on and observing if elements come on. Check heater
circuit with voltmeter.
Perform necessary repairs or tests.
Clear the unit of personnel before starting the griddle.
Turn power on at main panel.
Announce unit is "on" to other personnel.
Controls
The broiler turns on with the power switch of the griddle.
The broiler operates with full power when it is in the closed position. In the open position, the broiler will
operate with partial power and be in the "idle" mode.
Technical
The broiler, not including the griddle, is standard 208 or 240V, single phase. Specify voltage when
ordering.
Receiving the Unit
Upon receipt, check for freight damage, both visible and concealed. Note visible damage on the freight
bill at the time of delivery and have the carrier's agent sign the freight bill at that time. Concealed loss or
damage means loss or damage, which does not become apparent until the merchandise has been
unpacked. Make a written request for inspection upon unpacking and finding concealed damage within
15 days of delivery. Keep all packing material for inspection. Do not return damaged merchandise to
Star Manufacturing Company. File your claim with the carrier.
Location
Prior to un-crating, move the unit as near its intended location as practical. The crating will help protect
the unit from the physical damage normally associated with moving it through hallways and doorways.
Un-crating
The unit will arrive completely assembled inside a wood frame covered by cardboard box and strapped
to a skid. Remove the cardboard cover, cut the straps and remove the wood frame.
THE UNIT IS EXTREMELY HEAVY. FOR SAFE HANDLING, INSTALLER
SHOULD OBTAIN HELP AS NEEDED OR EMPLOY APPROPRIATE
MATERIALS-HANDLING EQUIPMENT (SUCH AS A FORKLIFT, DOLLY OR
PALLET JACK) TO REMOVE THE UNIT FROM THE SKID AND MOVE IT TO
THE PLACE OF INSTALLATION.
CAUTION
ANY STAND, COUNTER OR OTHER DEVICE ON WHICH THE UNIT WILL
BE LOCATED MUST BE DESIGNED TO SUPPORT THE WEIGHT OF THE
UNIT.
SHIPPING STRAPS ARE UNDER TENSION AND CAN SNAP BACK WHEN
CUT.
Remove the unit from the skid.
6