Lang Electric Clamshell CSE12-208VCD Installation, Operation And Maintenance Instructions page 3

THE UNIT IS EXTREMELY HEAVY. FOR SAFE HANDLING, INSTALLER
SHOULD OBTAIN HELP AS NEEDED OR EMPLOY APPROPRIATE
MATERIALS-HANDLING EQUIPMENT (SUCH AS A FORKLIFT, DOLLY OR
PALLET JACK) TO REMOVE THE UNIT FROM THE SKID AND MOVE IT TO
CAUTION
THE PLACE OF INSTALLATION.
ANY STAND, COUNTER OR OTHER DEVICE ON WHICH UNIT WILL BE
LOCATED MUST BE DESIGNED TO SUPPORT THE WEIGHT OF THE UNIT.
WHEN CUTTING SHIPPING STRAPS, USE CAUTION, THE SHIPPING
STRAPS ARE UNDER TENSION AND CAN SNAP BACK WHEN CUT,
DANGER
CAUSING SERIOUS INJURY AND OR DEATH.
GROUND THIS APPLIANCE AT THE TERMINAL PROVIDED. FAILURE TO
DANGER
COMPLY MAY RESULT IN SERIOUS INJURY AND/OR DEATH.
INSTALLATION OF THE UNIT MUST BE DONE BY PERSONNEL
QUALIFIED TO WORK WITH ELECTRICITY AND PLUMBING. IMPROPER
WARNING
INSTALLATION CAN CAUSE INJURY TO PERSONNEL AND/OR DAMAGE
TO EQUIPMENT. UNIT MUST BE INSTALLED IN ACCORDANCE WITH ALL
APPLICABLE CODES.
BROILER ELEMENTS CAN IGNITE GREASE FIRES ON THE GRIDDLE
SURFACE, WHICH MAY RESULT IN PROPERTY DAMAGE, SERIOUS
WARNING
INJURY OR DEATH. ENSURE GRIDDLE SURFACE IS SLOPPED DOWN
FROM BACK TO FRONT BY AT LEAST ¼" BEFORE COOKING
The data plate is located behind the Clamshell® between the two pivot
arms. The Clamshell® voltage, wattage, serial number, wires size and
clearance specifications are on the data plate. This information should be
carefully read and understood before proceeding with the installation.
The installation of any components such as a vent hood, grease
NOTICE
extractors or fire extinguisher systems must conform to their applicable
National, State and locally recognized installation standards.
During the first few hours of operation you may notice a small amount of
smoke and a faint odor from the smoke. This is normal for a new unit and
will disappear after the first few hours of use.
ALWAYS KEEP THE AREA NEAR THE APPLIANCE FREE FROM
COMBUSTIBLE MATERIALS.
CAUTION
KEEP FLOOR IN FRONT OF EQUIPMENT CLEAN AND DRY. IF SPILLS
OCCUR, CLEAN IMMEDIATELY TO AVOID THE DANGER OF SLIPS OR
FALLS.
KEEP WATER AND SOLUTIONS OUT OF CONTROLS. NEVER SPRAY OR
WARNING
HOSE CONTROL CONSOLE, ELECTRICAL CONNECTIONS, ETC.
MOST CLEANERS ARE HARMFUL TO THE SKIN, EYES, MUCOUS
MEMBRANES AND CLOTHING. PRECAUTIONS SHOULD BE TAKEN TO
WEAR RUBBER GLOVES, GOGGLES OR FACE SHIELD AND
CAUTION
PROTECTIVE CLOTHING. CAREFULLY READ THE WARNING AND
FOLLOW THE DIRECTIONS ON THE LABEL OF THE CLEANER TO BE
USED.
ETL File 68964 3
SAFETY
Rev.A2007