Power / Switching The Effect On And Off; Audio In And Out - TC Electronic Flashback Triple Delay Manual

Power / Switching the
effect on and off
Power input
To power up your pedal, connect a power supply
to its power input socket.
The power input socket of your TC Electronic
effect pedal is a standard 5.5 / 2.1 mm DC plug
(centre = negative).
Your TC Electronic effect pedal requires a 9 V
power supply providing 300 mA or more (sup-
plied). You may also use another 9 V or 12 V
power supply, as long as it provides 300 mA or
more.
To minimize hum, use a power supply with iso-
lated outputs.
Flashback Triple Delay English manual 2014-10-14

Audio in and out

Audio inputs (stereo)
The audio inputs on the back of this pedal are
standard ¼" jacks (mono/TS).
►
If your signal source is mono, connect it to the
MONO in jack of the pedal.
► If your signal source is stereo, connect the ca-
ble carrying the left signal component to the
MONO IN jack and the cable carrying the right
signal component to the STEREO IN jack.
Inputs, outputs and controls
Audio outputs (stereo)
The audio outputs on the back of this pedal are
standard ¼" jacks (mono/TS).
►
If the next device in the signal chain has
a mono input (e.g. your amp), connect the
MONO OUT jack of TC Electronic effect pedal
to the other device's input.
► If the next device in the signal chain has ste-
reo inputs (e.g. another stereo effect pedal),
connect the MONO OUT jack of your TC Elec-
tronic effect pedal to the left input and the
STEREO OUT jack to the right input of the
other device.
16