Table of Contents
Advertisement
6.0
E
C
LECTRICAL
All power and control wiring and power connections must be in accordance with the National Electri-
cal Code (NEC) and local codes. Refer to the unit's serial tag for electrical requirements.
CAUTION
!
Use copper wiring only. Make sure that all connections are tight.
The voltage supplied must agree with the voltage specified on the unit serial tag.
NOTE
All electrical data maybe found in Table 4 - XDO specifications.
Figure 18 XDO electrical connection diagram
To supply
6.1
Connecting High Voltage Cables
WARNING
!
Risk of electric shock. Can cause injury or death.
Disconnect all local and remote electric power before working within the unit.
CAUTION
!
Sharp edges and heavy parts may cause personal injury.
Wear gloves to prevent injury to hands.
Damage to wiring or components may make unit unsafe to operate.
Use caution when installing wiring to prevent damage to factory wiring.
Install protective bushings in wiring knockouts as required
Do not disturb factory wiring or route field-installed wiring over electrical terminals.
Use NEC Class 1 wiring for all hazardous voltage electrical power supplies.
Check and retighten all wiring connections before starting.
The XDO is designed for electrical access through the top or front (see Figure 19).
ONNECTIONS
XDO
E
E = Electrical Connection Point
XDO
E
18
: http://splitoff.ru/tehn-doc.html
Electrical Connections
To other XDO units
To other XDO units
XDO
E
Advertisement
Table of Contents
