Table of Contents
Advertisement
5.3
Installation With External Mounting Brackets
An optional external mounting bracket kit may be used to hang XDO units. This kit attaches to the
front and rear of the XDO and are used to secure the unit to the overhead building structure.
To use the external mounting brackets:
1. Attach two field-supplied threaded rods to a mounting bracket, using two nuts, two washers and a
bushing, as shown in Figure 17.
Figure 16 External mounting kit for XDO
2. Place the bracket against either the front or rear panel of the XDO, making sure that the lip along
the bottom of the bracket fits under the bottom of the panel.
3. Secure the bracket to the XDO using three nuts and bolts supplied with the mounting kit as
shown in Figure 17.
4. Using either lifting equipment or adequate personnel, raise the XDO to mounting connections
installed in the overhead building structure and secure the unit using field-supplied hardware.
Attaching Suspension Hardware and Mounting the Unit
16
: http://splitoff.ru/tehn-doc.html
Advertisement
Table of Contents
