Husqvarna 522HD60S Operator's Manual page 22

• If Husqvarna two-stroke oil is not available, use a
two-stroke oil of good quality for air-cooled engines.
Speak to your servicing dealer to select the correct
oil.
CAUTION: Do not use two-stroke oil for
water-cooled outboard engines, also
referred to as outboard oil. Do not use oil
for four-stroke engines.
To mix gasoline and two-stroke oil
Gasoline, liter
5
10
15
20
CAUTION: Small errors can influence the
ratio of the mixture drastically when you mix
small quantities of fuel. Measure the quantity
of oil carefully and make sure that you get
the correct mixture.
1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION: Do not mix fuel for more than 1
month at a time.
22
To fill the fuel tank
1. Clean the area around the fuel tank cap.
2. Shake the container and make sure that the fuel is
Two-stroke oil,
fully mixed.
liter
3. Tighten the fuel tank cap carefully.
2% (50:1)
4. Move the product 3 m/10 ft or more away from the
refueling area and fuel source before starting.
0.10
0.20
Note: To see where the fuel tank is on your product,
Product overview 522HD60S on page 15 .
refer to
0.30
To install the blade tip protection
0.40
522HD60S
1. Remove the nut and the bolt on the blade tip.
2. Install the blade tip protection on the blade tip.
3. Install the bolt and tighten it to 7 Nm.
4. Install the nut and tighten it to 5 Nm.
To install the leaf catcher and the blade
tip protection 522HS75S
1. Remove the outer 8 nuts from the bolts on the blade.
2. Put the leaf catcher on the 8 bolts. Refer to
overview 522HS75S on page 16 , to see where the
leaf catcher is on the product.
3. Put the blade tip protection on the 2 bolts on the tip
of the blade.
4. Install the 8 nuts to the bolts.
5. Torque the nuts to 7 Nm.
To adjust the handle 522HD60S
The rear handle can be adjusted into 3 positions.
Product
938 - 001 - 18.03.2019