KVH Industries TracVision 6 Technical Manual page 12

TracVision 6 Technical
Manual Addendum
(ECO #5503)
The following changes have been made to Revision B of the
TracVision 6 Installation and Technical Manual (KVH Part
Number 54-0166).
4.4 PCB Removal and Replacement
The CPU Printed Circuit Board (PCB) has been changed from an
"L"-shaped design to a simpler straight design. Figure 4-3 has been
updated to show the new CPU PCB.
From Elevation Motor
From Azimuth Motor
From RFU to CPU Cable
From Cable Wrap
CPU PCB
From Elevation Limit Switch
4.4.1 CPU Board
The new CPU Board is secured to the antenna frame using nine screws
rather than eleven.
2. Remove nine #6-32 machine screws from the PCB.
54-0166 Addendum to Rev. B
From Azimuth Limit Switch
TracVision 6 Installation and Technical Manual – ADDENDUM
From Cable Wrap
Figure 4-3
PCB Connector Locations
(Rear View)
RFU to CPU
RFU PCB
From LNB
From Cable Wrap
From Antenna Sensor
1